Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Uživatelský manuál stáhnout pdf (Strana 17)

E8 Controller and BCM for Modulex EXT

Installation, Operation & Maintenance Manual

CHAPTER 4: E8 INITIALIZATION AND QUICK START GUIDE

OMM-0093_0A AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 17 of 108

GF-136-C Ph.: 800-526-0288 PRI: 06/24/2013

CHAPTER 4: E8 INITIALIZATION AND QUICK START GUIDE

4.1 Initializing the E8 in the Installation Menu

When power is first applied to the boiler and then the E8 controller cover is opened, the

INSTALLATION

Menu is displayed once (only). See Figure 4-1 for a diagram of this menu.

These values MUST be entered in order to initialize the boiler for operation. Once the

LANGUAGE

TIME

and

DATE

values grouped here have been entered and accepted, the

controller is initiated and operatable and may be configured for your boiler installation. To re-

enter the

INSTALLATION

menu, cycle the boiler power and open the cover again.

To initialize the E8 Controller, follow the instructions below and refer to Figure 4-1 and Table 4-1

on the following pages:

Initial Startup INSTALLATION Entry

1. Set the POWER rocker switch, located to the left of the Controller, to the ON (I) position.

2. Open the panel cover on the Controller. The LCD display will read INSTALLATION. All

values in this level must be entered, in sequence, without interruption.

3. The first function that appears is LANGUAGE. By default, the display should show

ENGLISH. If ENGLISH is not displayed, turn the Rotary Knob until ENGLISH appears.

4. Press the Program Key to store this setting.

5. Next, TIME will be displayed. Enter the current time (minutes, hours) using the Rotary

Knob. Press the Program Key to store each value.

6. The next items displayed are the YEAR, MONTH and DAY. Enter each item using the

Rotary Knob and press the Program Key as previously described to store the entry.

7. Following entry of all LANGUAGE, TIME and DATE entries, continue entering the

remaining items shown in Figure 4-1 and Table 4-1 until all required items have been

entered. Use the Program Key and Rotary Knob to select, adjust and store all entries as

previously described.

NOTE

Leave the BUS – ID HS parameter blank. Remaining parameters

are already set and do not require any entry.

8. Continue step 7 until RETURN appears in the display, indicating that you are at the end

of the INSTALLATION menu.

9. Press the Program Key to exit the INSTALLATION menu.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 107 108

Komentáře k této Příručce

Žádné komentáře

Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Uživatelský manuál Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo